GRC是一种以耐碱玻璃纤维为增强材料、水泥砂浆为基体材料的纤维混凝土复合材料，GRC是一种通过模具造型、纹理、质感与色彩表达设计师想象力的材料。那么厂家生产济南GRC构件过程中，监理单位和项目工程部应进行过程跟踪检查，确保厂家依合同、规范施工。其中制品材料应符合下列要求：

GRC is a kind of fiber concrete composite material with alkali-resistant glass fiber as the reinforcement material and cement mortar as the matrix material. GRC is a material that expresses the designer's imagination through mold modeling, texture, texture and color. During the production of Jinan GRC components by the manufacturer, the supervision unit and the project engineering department shall carry out process tracking inspection to ensure that the manufacturer works in accordance with the contract and specifications. The product materials shall meet the following requirements:

1.水泥：低碱度硫铝酸盐水泥；

1. Cement: low alkalinity sulphoaluminate cement;

2.集料：砂子含泥量不得大于1.0%，喷射工艺用砂的大粒径应小于1.2mm，预混或铺网抹浆工艺用砂的大粒径应小于2.4mm，0.15mm以下颗粒的含量应小于10%；加强肋或填充空腔用混凝土中砂子的粒径不受此限制；严禁使用海砂。

2. Aggregate: the silt content of sand shall not be greater than 1.0%, the large particle size of sand for spraying process shall be less than 1.2 mm, the large particle size of sand for pre-mixing or mesh plastering process shall be less than 2.4 mm, and the content of particles below 0.15 mm shall be less than 10%; The particle size of sand in the concrete for reinforcing ribs or filling cavities is not subject to this restriction; Sea sand is strictly prohibited.

3.GRC构件制品应按设计图纸制造，其外观尺寸应符合下表规定：

3. GRC component products shall be manufactured according to the design drawings, and their appearance dimensions shall comply with the following table:

4.构件的物理性能要求：

4. Physical performance requirements of components:

5.原材料出厂前后质量控制要点：

5. Key points of quality control of raw materials before and after delivery:

在制品明显位置固定标明生产单位、商标、产品标记、生产日期以及“严禁碰撞”等字样的标志。

Signs indicating the manufacturer, trademark, product mark, production date and the words "No Collision" shall be fixed at the obvious position of the products.

堆放：按规格型号分类堆放，堆放场地应平整、干燥、通风，堆放高度不应超过1.8米，堆放层数不应超过四层。

Stacking: The stacking shall be classified according to the specifications and models. The stacking site shall be flat, dry and ventilated. The stacking height shall not exceed 1.8m, and the number of stacking layers shall not exceed four.

装卸、运输：

Loading, unloading and transportation:

装卸及搬运制品时，必须轻装轻放，严禁抛掷。运输时应固定牢靠，防止晃动，必要时在制品间用草垫隔开，制品不得超出车厢长度。

When loading, unloading and handling products, they must be handled with care and must not be thrown. During transportation, it shall be firmly fixed to prevent shaking. If necessary, the product room shall be separated by straw mats. The product shall not exceed the length of the carriage.

制品出厂应提交出厂证明书，其内容包括：

The ex-factory certificate shall be submitted when the product leaves the factory, and its contents include:

1）产品标记及数量；

1) Product marking and quantity;

2）出厂检验结果；

2) Delivery inspection results;

3）生产日期及出厂日期；

3) Production date and ex-factory date;

4）生产单位名称及商标；

4) Name and trademark of the manufacturer;

5）生产单位质检部门签章。

5) Signature and seal of the quality inspection department of the production unit.

GRC主要运用在建筑领域，用于建筑外立面装饰以及室内空间的外墙面装饰，也可以用于建筑装饰构件和景观小品。所以说，您对此有需求，就来我们网站留言咨询并随时联系我们http://www.aswjc.com做选购！

GRC is mainly used in the field of architecture, for building facade decoration and exterior wall decoration of indoor space, and also for building decoration components and landscape sketches. So, if you have any need for this, please come to our website to leave a message and contact us at any time http://www.aswjc.com Do shopping!